If your TM2 vehicle did not come with Side Air Vents installed, and you would like a set, you can contact us and we will send you some. Follow the instructions below (you can also download these instructions as a PDF at the bottom of this article):


  • Side vent templates (Left and Right)

  • Centre punch

  • Hammer

  • Drill

  • Various drill bits (incl. 8mm, 10mm)

  • Scissors

  • Ruler

  • Scribe (or other marking tool)

  • Cut-off wheel (or similar cutting tool)

  • Dust filtering half mask & Safety goggles

  • 8mm socket and ratchet

  • Sikaflex-Auto (or similar adhesive)

  • Clamp


Cutting fibreglass is hazardous to your health.

Ensure you wear a protective dust filtering half mask - fibreglass particles when breathed in are carcinogenic.

It has been discovered that chemical hardener and catalysts used with some fibreglass resins can cause permanent blindness.

You must wear goggles when cutting and handling these materials.


NOTE: This guide uses the right-hand side vent as an example.

The process is identical for the left-hand side vent.


NOTE: Please call us anytime to discuss the installation of the guards on 1800 TOMCAR